Download a firmware upgrade that supports this feature. Step 4: Configure the Network Management Card 6. Schneider Electric Critical Power & Cooling Services (CPCS) provides the expertise, services, and support you need for your building, industry, power, or data center infrastructure. Network Management Device IP Configuration Wizard v5.0.2. Embedded Network Management Cards Using the Wizard.

– For embedded Network Management Cards, the MAC address is on a label on the device containing the card - for example, usually on the side of a device that you mount in a rack.ĭownload APC Device IP Configuration Wizard You can use the APC Device IP Configuration Download page for. Jack And The Beanstalk The Real Story 2001 Download. (The Wizard displays the MAC address for a discovered card on the same screen on which you then enter the TCP/IP settings.) – For Network Management Cards that you install, the MAC address is on a label on the bottom of the card. If you are configuring multiple unconfigured Network Management Cards, obtain the MAC address of each one so that you can identify each Network Management Card that the Wizard discovers. Contact your network administrator to obtain valid TCP/IP settings to use. Before you run the Wizard, be sure that you have the information you will need during the configuration procedure: 1. Configure the basic TCP/IP settings remotely Prepare to configure the settings. Use the Wizard Launch the Wizard The installation creates a shortcut link in the Start menu that you can use to launch the Wizard. System requirements The Wizard runs on Windows NT ®, Windows 2000, Windows 2003, and Windows XP Intel-basedworkstations. The Wizard can discover and configure Network Management Cards only if they are on the same network segment as the computer that is running the Wizard. Configure or reconfigure a Network Management Card through a direct connection from the serial port of your computer to the device that contains the card.Automatically discover and configure unconfigured Network Management Cards remotely over your TCP/IP network.Devices that contain embedded Network Management Cards Using the Wizard, you can configure the basic TCP/IP settings of installed or embedded Network Management Cards in either of the following ways:.APC Device IP Configuration Wizard Purpose and Requirements Purpose: configure basic TCP/IP settings You can use the APC Device IP Configuration Wizard to configure the basic TCP/IP settings (IP address, subnet mask, and default gateway) of the following:

Hog Pc Usb Dmx Widget Driver